RUPTELA FM Pro - Page 22

R&D department
2018/08/01
id=256,profile=4,enable=1,level=3500,delta=250,average=2000,eventon=2,include=1,priority=1,switch=1,edge=3
This SMS can be used in any way, but it must at least contain Id,profile and enable parameters. Shortest possible
message should be written this way:
password setioparam id=id,profile=profile,enable=enable
Example:
01234567890123456 setioparam id=256,profile=4,enable=1
If the short version is used the other parameters are set with old values. Id,profile and enable parameters are
mandatory to make a valid SMS command.
Note that only two spaces between password[space]setioparam[space]id are required. All other commands are
separated by comma.
SMS can be written in lower case and upper case letters. Therefore, setioparam SMS is not case sensitive.
If SMS command doesn’t define new values to level, delta, average, eventOn, include, priority, switch or edge
parameters, it will not be changed. Previous value will remain.
When the FM-device receives the SMS where the parameter enable is set to 1, it searches in the current
configuration if this parameter with the same ID is already enabled.
– If parameter with the same ID was not enabled, FM-device will set this IO parameter to the first free slot that is
available.
– If IO parameter with the same ID was enabled, FM-device will overwrite the IO parameter with new values.
– If FM-device finds more than one IO parameters with the same ID it will send an error message.
If newly created IO event is not set to specific parameters it will be set to default. Default values are listed below:
Level Delta Average EventOn Include Priority Switch Edge
0 0 1000 2 0 0 0 0
For set enable, eventOn, include, priority, switch on edge it is necessary to indicate the state with a number:
Enable EventOn Include Priority Switch Edge
0 – disable
1 – enable
0 – Hysteresis
1 – Change
2 – Monitoring
0 – not include data
1 – include data
0 – Low
1 – High
0 – no switch
1 – 1
st
profile
2 – 2
nd
profile
3 – 3
rd
profile
4 – 4
th
profile
0 – On Both
1 – On rising
2 – On falling
22