R&D department
2018/08/01
• Power supply voltage - “Event on” set to Hysteresis and hysteresis must be set to On Falling ;
• GPS speed - “Event on” set to Hysteresis and hysteresis must be set to On Rising.
After the “Event on” parameter is properly set, a new checkbox will appear at the top of the IO properties section called
“SMS alert”. Put a tick in this checkbox to receive SMS alerts for the selected I/O parameter.
Afterwards, when a I/O is triggered, the device will send an SMS alert to the number previously specified in the
“Authorized number”.
Notes
If the device was out of the GSM coverage, the FM device will accumulate events that will be sent as soon as GSM
connectivity is restored. The FM device can store up to 16 events. If the 16 event threshold is reached, the device will
start to overwrite oldest events. The device will send a report of all events in ONE message (as many, that can fit in 160
characters). Multiple events in one SMS message will be delimited by a semicolon symbol “;”.
Message format:
date1&time1-event1; date2&time2-event2; …
Examples:
2015.05.01 16:24:01-device disconnected;
2015.06.02 22:05:16-ignition: ON; 2015.06.02 22:05:35-DIN1: OFF;
2015.06.14 08:30:45-overspeed;
Additionally the SMS alert function now supports custom SMS text. Custom text fields appear after the “SMS alert”
checkbox is clicked. The maximum custom text length is 50 symbols, all previous rules apply.
41
To Previous Page
Loading...
