Revision 4 - December 17,1998 Ryan TCAD 9900 Series Page 2-7
2.11 MECHANICAL INSTALLATION OF PROCESSOR
Listed below are factors and suggestions to consider before installing the Ryan TCAD
Processor and Mounting Tray. Close adherence to these suggestions will assure optimum
performance.
A. Allow adequate space for installation of cables and connectors.
B. Install the Processor in the avionics bay. If installed at a location other
than the avionics bay, the location should be structurally substantiated.
Figure 2-6 Processor Mounting Tray
To Next Page
Loading...
Need help?
General
