Earthing Instructions
• This appliance must be earthed� In the event of a malfunction
or breakdown, earthing will reduce the risk of an electric shock
by providing a path of least resistance of electric current� This
appliance is equipped with an earthing conductor plug�
• The plug must be plugged into an appropriate outlet that is
installed and earthed in accordance with all local codes and
ordinances�
• Improper connection of the equipment-earthing conductor
can result in the risk of an electric shock�
• Check with a qualied electrician or service representative if
you are in doubt whether the appliance is properly grounded�
• Do not modify the plug provided with the appliance; If it does
not t the outlet�
• Have a proper outlet installed by a qualied electrician�
• Do not abuse, sit on, or stand on the door or dish rack of the
dishwasher�
• Do not operate your dishwasher unless all enclosure panels are
properly in place�
• Open the door very carefully if the dishwasher is operating,
there is a risk of water squirting out�
• Do not place any heavy objects on or stand on the door when
it is open� The appliance could tip forward�
• When loading items to be washed:
1)� Locate sharp items so that they are not likely to damage the door
seal;
2)� Warning: Knives and other utensils with sharp points must be
loaded in the basket with their points facing down or placed in a
horizontal position�
• Some dishwasher detergents are strongly alkaline� They can be
extremely dangerous if swallowed� Avoid contact with the skin
and eyes and keep children away from the dishwasher when
the door is open�
• Check that the detergent powder is empty after completion of
the wash cycle�
• Do not wash plastic items unless they are marked «dishwasher
safe» or the equivalent�
• For unmarked plastic items not so marked, check the
manufacturer’s recommendations�
• Use only detergent and rinse agents recommended for use in
an automatic dishwasher�
• Never use soap, laundry detergent, or hand washing detergent
in your dishwasher�
• The door should not be left open, since this could increase the
risk of tripping�
• If the supply cord is damaged, it must be replaced by the
manufacturer or its service agent or a similarly qualied
person in order to avoid a hazard�
• During installation, the power supply must not be excessively
or dangerously bent or attened�
• Do not tamper with controls�
• The appliance needs to be connected to the main water valve
using new hose sets� Old sets should not be reused�
6968
To Next Page
Loading...
Need help?
General
