EasyManuals Logo
Home>Saba>Dishwasher>LVIF1019A++44M

Saba LVIF1019A++44M User Manual

Saba LVIF1019A++44M
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #43 background imageLoading...
Page #43 background image
Electrical connection
Ensure the voltage and frequency of the power being corresponds
to those on the rating plate� Only insert the plug into an electrical
socket which is earthed properly� If the electrical socket to which
the appliance must be connected is not appropriate for the plug,
replace the socket, rather than using an adaptors or the like as
they could cause overheating and burns�
Ensure that proper earthing exists before use
Water Supply And Drain
Cold water connection
Connect the cold water supply hose to a threaded 3/4(inch)
connector and make sure that it is fastened tightly in place�
If the water pipes are new or have not been used for an extended
period of time, let the water run to make sure that the water is
clearThis precaution is needed to avoid the risk of the water inlet
to be blocked and damage the appliance�
ordinary supply hose
safety supply hose
About the safety supply hose
The safety supply hose consists of the double wallsThe hoses
system guarantees its intervention by blocking the ow of water
in case of the supply hose breaking and when the air space
between the supply hose itself and the outer corrugated hose is
full of water
WARNING
A hose that attaches to a sink spray can burst if it is installed on
the same water line as the dishwasher� If your sink has one, it
is recommended that the hose be disconnected and the hole
plugged�
How to connect the safety supply hose
1� Pull the safety supply hoses completely out from storage
compartment located at rear of dishwasher
2� Tighter the screws of the safety supply hose to the faucet with
thread 3/4inch�
3� Turn water fully on before starting the dishwasher
How to disconnect the safety supply hose
1� Turn o the water
2� Unscrew the safety supply hose from the faucet
Connection Of Drain Hoses
Insert the drain hose into a drain pipe with a minimum diameter
of 4 cm, or let it run into the sink, making sure to avoid bending
or crimping it� The height of drain pipe must be less than
1000mm� The free end of the hose must not be immersed in
water to avoid the back ow of it
8382
GB GB

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Saba LVIF1019A++44M and is the answer not in the manual?

Saba LVIF1019A++44M Specifications

General IconGeneral
BrandSaba
ModelLVIF1019A++44M
CategoryDishwasher
LanguageEnglish

Related product manuals