Saba LVIF1019A++44M - Filling and Adjusting Reservoirs; Filling the Rinse Aid Reservoir; Adjusting Rinse Aid Level; Filling the Detergent Dispenser

Filling The Rinse Aid Reservoir
1� Remove the rinse aid
reservoir cap by rotating
it counter clockwise�
2� Carefully pour in
the rinse-aid into
its dispenser, whilst
avoiding it to overow�
3� Close the rinse aid
reservoir cap by rotating
it clockwise�
NOTE:
Clean up any spilled rinse
aid with an absorbent cloth
to avoid excessive foaming
during the next wash�
Adjusting the rinse aid reservoir
Turn the rinse aid indicator dial to a number
between 1 and 6� The higher the number, the
more rinse aid the dishwasher uses� If the dishes
are not drying properly or are spotted, adjust the
dial to the next higher number until your dishes
are spot-free� Reduce it if there are sticky whitish
stains on your dishes or a bluish lm on glassware
or knife blades�
adjust lever(Rinse)
Filling The Detergent Dispenser
Push latch to open
1� Press the release catch on
the detergent dispenser to
open the cover�
2� Add detergent into the larger
cavity (A) for the main wash
cycle�
For more heavily soiled
wash loads, also add some
detergent into the smaller
cavity (B) for the pre-wash
cycle�
3� Close the cover and press on
it until it locks into place�
NOTE:
• Be aware that depending on the soiling of water, setting may
be dierent�
• Please observe the manufacturer's recommendations on the
detergent packaging�
115114
GB GB