NOTE:
EN 50242: This program is the test cycle� The information for
comparability test in accordance with EN 50242�
Starting A Cycle Wash
1� Draw out the lower and upper basket, load the dishes and push
them back� It is commended to load the lower basket rst, then
the upper one�
2� Pour in the detergent�
3� Insert the plug into the socket� The power supply refer to last
page "Product che"� Make sure that the water supply is turned
on to full pressure�
4� Close the door, press the Power button, to switch on the
machine�
5� Choose a program, the response light will turn on� Then press the
Start/Pause button, the dishwasher will start its cycle�
Changing The Program Mid-cycle
A wash cycle can only be changed if it has been running for a
short time otherwise, the detergent may have already been
released and the dishwasher may have already drained the wash
water� If this is the case, the dishwasher needs to be reset and
the detergent dispenser must be relled� To reset the dishwasher,
follow the instructions below:
1� Open the door a little to stop the dishwasher, after the spray arm
stop working, you can open the door completely�
2� Press Program button more than three seconds the machine will
be in stand by state�
3� You can change the program to the desired cycle setting�
Forget To Add A Dish?
A forgotten dish can be added any time before the detergent
dispenser opens� If this is the case, follow the instructions below:
1� Open the door a little to stop the washing�
2� After the spray arms stop working, you can open the door
completely�
3� Add the forgotten dishes�
4� Close the door�
5� The dishwasher will start running again�
WARNING
It is dangerous to open the door mid-cycle, as hot
steam may scald you�
119118
To Next Page
Loading...
