Using your dishwasher
1� Set the water softener
2� Loading the salt into the softener
3� Loading the basket
4� Fill the dispenser
Please check the section 1 «Water Softener» of PART II:
Special Version, if you need to set the water softener.
Loading the Salt Into The Softener
NOTE:
If your model does not have any water softener, you may skip this
section� Always use salt intended for dishwasher use�
The salt container is located beneath the lower basket and should
be lled as explained in the following:
WARNING
• Only use salt specically designed for dishwashers use!
Every other type of salt not specically designed for
dishwasher use, especially table salt, will damage the water
softener� In case of damages caused by the use of unsuitable
salt the manufacturer does not give any warranty nor is liable
for any damages caused�
Inside Outside
• Only ll with salt before running a cycle.
This will prevent any grains of salt or salty water, which may
have been spilled, remaining on the bottom of the machine for
any period of time, which may cause corrosion�
Please follow the steps below for adding dishwasher salt:
1� Remove the lower basket and unscrew the reservoir cap�
2� Place the end of the funnel (supplied) into the hole and pour in
about 1�5kg of dishwasher salt�
3� Fill the salt container to its maximum limit with water, It is
normal for a small amount of water to come out of the salt
container�
4� After lling the container, screw back the cap tightly�
5� The salt warning light will stop being after the salt container has
been lled with salt�
6� Immediately after lling the salt into the salt container, a
washing program should be started (We suggest using a short
program)� Otherwise the lter system, pump or other important
parts of the machine may be damaged by salty water� This is out
of warranty�
Before using your dishwasher
7372
To Next Page
Loading...
Need help?
General
