Step 4. Dishwasher installation steps
Please refer to the specied installation steps in the installation
drawings�
1� Ax the condensation strip under the work surface of cabinet�
Please ensure the condensation strip is ush with edge of work
surface� (Step 2)
2� Connect the inlet hose to the cold water supply�
3� Connect the drain hose�
4� Connect the power cord�
5� Place the dishwasher into position� (Step 4)
6� Level the dishwasher� The rear food can be adjusted from the
front of the dishwasher by turning the Philips screw in the
middle of the base of dishwasher use an Philips screw� To adjust
the front feet, use a at screw driver and turn the front feet until
the dishwasher is level� (Step 5 to Step 6)
7� Install the furniture door to the outer door of the dishwasher�
(Step 7 to Step 10)
8� Adjust the tension of the door springs by using an Allen key
turning in a clockwise motion to tighten the left and right
door springs� Failure to do this could cause damage to your
dishwasher� (Step 11)
9� The dishwasher must be secured in place� There are two ways to
do this:
A� Normal work surface: Put the installation hook into the slot of
the side plane and secure it to the work surface with the wood
screws�
B� Marble or granite work top: Fix the side with Screw�
Step 5. Levelling the dishwasher
Dishwasher must be level for proper dish rack operation and
wash performance�
1� Place a spirit level on door and rack track inside the tub as shown
to check that the dishwasher is level�
2� Level the dishwasher by adjusting the three levelling legs
individually�
3� When level the dishwasher, please pay attention not to let the
dishwasher tip over�
Check level - front to back
Check level side to side
NOTE:
The maximum adjustment
height of the feet is 50 mm�
9190
To Next Page
Loading...
