Saeco HD8914 - Activation and Deactivation; First Start Procedures; Water Circuit Priming; Automatic Rinse;Self-Cleaning Cycle

6
ENGLISH
5. Activation and deactivation
Make sure to read the “3. Safety” chapter.
5.1 Using the selection buttons
Some function buttons can be used to navigate through functions / menus:
TheOKbuttonisusedtoselect/conrm/stopthefunction.
The ESC button is used to return to the main menu, one level at a time.
The UP button is used to move upwards.
The DOWN button is used to move downwards.
5.2 First start
Beforerstusethefollowingoperationsmustbecarriedout:
• Water circuit priming.
• One automatic rinse/self-cleaning cycle.
• One manual rinse cycle.
5.2.1 Water circuit priming
Duringthisprocessfreshwaterowsthroughtheinternalcircuitandthemachine
heats up. The process requires a few minutes.
> Check that the automatic milk frother is not installed.
> Place a container under the steam wand.
>
Press the OK button to start the water circuit priming cycle. The machine starts
dispensing hot water through the steam wand. The progress bar on the display shows
the status of the operation. The machine automatically stops dispensing water at the
end of the process. The display shows that the machine is heating. At the end of the
heating phase, the machine launches an automatic clean water rinse/self-cleaning cycle
of the internal circuits.
5.2.2 Automatic rinse/self-cleaning cycle
> Place a container under the coffee dispensing spout.
Burning hazard! Be careful of hot water or steam sprays.
The operation lasts less than a minute. Wait for the cycle to end automatically.
If necessary, the cycle can be interrupted by pressing the OK button.
> Empty the container. The machine goes back to the main menu.
Now it is possible to launch the manual rinse cycle.
5.2.3 Manual rinse cycle
The complete manual rinse cycle comprises two consecutive phases:
• One “Coffee brewing circuit rinsing phase”, to be repeated for three times.
• One “Hot water dispensing circuit rinsing phase”.
Coffee brewing circuit rinsing phase
Duringthisphase,thecoffeebrewingcycleisstartedandfreshwaterowsthrough
the water circuit. The process requires a few minutes.
If necessary, perform the “4.2 Water tank lling” chapter.
Do not place pre-ground coffee in the pre-ground coffee compartment.
> Place a container under the coffee dispensing spout.
Burning hazard! Be careful of hot water or steam sprays.
> Press the AROMA STRENGTH button repeatedly, to select the pre-ground coffee
brewing function.
> Press the ESPRESSO LUNGO button. The machine starts dispensing water from the
coffee dispensing spout.
If necessary, the cycle can be interrupted by pressing the OK button.
> After the product has been brewed, empty the container.
Repeat the previous operations twice, then proceed.
Incanto_AMF_EN-IT-DE_Rev01.indb 6 27/03/15 09:57