Saeco HD8914 - Warnings Signals Summary; Technical Specifications; Transportation and Disposal; Warranty and Service

18
ENGLISH
Display Description Action
Water tank empty.
Follow the relevant instructions in the “4.2 Water
tank lling” chapter.
XX
The machine is out of service.
Follow the relevant instructions in the “9.3 The
machine is out of service” chapter.
9.2 Warnings signals summary
Display Description Action
The machine is ready to brew
products: coffee bean hopper empty.
Follow the relevant instructions in the “4.3 Coffee
bean hopper lling” chapter.
FILTER
Iftheltersignalstartsblinking,the
AquaCleanltermustbereplaced.
Follow the relevant instructions in the “10.2.2
AquaClean replacement” chapter.
The machine is waiting to start the
water circuit priming process.
Follow the relevant instructions in the “5.2.1 Water
circuit priming” chapter.
START
CALC
CLEAN
START
CALC
CLEAN
FILTER
The machine must be descaled.
Follow the relevant instructions in the “7.5 Descaling
cycle” chapter.
The machine is heating up. Wait.
The machine is rinsing. Wait.
Brew group rebooting. Wait.
9.3 The machine is out of service
If the machine error alarm signal is triggered, the error code is displayed in the bottom
right corner of the display.
Please, consult the following table.
Error
code
Behaviour Cause Action
1
Coffee grinder
blocked
Coffee outlet duct clogged
Clean the coffee outlet duct thoroughly as
described in the “7.2.1 Weekly brew group cleaning
cycle” chapter.
3 - 4
Brew group
locked, cannot be
taken out
The brew group is incorrectly
positioned.
Close the service door. Turn the machine off and
back on again. Wait for the ‘Ready for brewing’ signal
and then remove the brew group.
5
Water circuit
error
Air in the water circuit
Remove and restore the water tank a couple of
times, making sure to position it correctly. Check
that the water tank seat is clean.
For any other error code:
>
Turn the machine off and then back on again after 30 seconds.
>
Try 2 or 3 times.
If the machine does not start, contact the Philips Saeco hotline and mention the error
code shown on the display. Contacts are included in the warranty booklet supplied
separately or can be found at www.saeco.com/support.
XX
red
displa
y
Incanto_AMF_EN-IT-DE_Rev01.indb 18 27/03/15 09:58