Chapter 3: Service & maintenance
52 Troubleshooting guide
Replacing the fuse in the power connector
One fuse is installed in the power connector. If the fuse is blown, do as
follows:
1. Track down why the fuse was blown and solve the problem.
2. Take out the old fuse.
3. Insert the new fuse. The fuse rating is 10 A T.
WARNING:
POWER
SUPPLY
LOST
CONTACT
Power
supply
status
cannot be
monitored.
In Setup, Power Supply, set Monitor to disabled.
You can only monitor the power supply if the radio is
powered by a SAILOR 6081 Power Supply Unit and
Charger.
Action Symptom Remedy
To Next Page
Loading...
