Chapter 2: Using the system
24 Messages
• Load a file by selecting Options > Load and select a file to load into the
editor. You can then edit the text before you save it or send it. Note that
you cannot load a file if it contains characters that are not telex
characters.
Supported characters are: a b c d e f g h i j k l m n o p q r s t u v w x y z 0 1
2 3 4 5 6 7 8 9 - ? : ( ) . , ' = / +
4. When the message is complete, you can either send the message (skip the
next steps and go directly to step 8) or save it for later use.
5. To save the message, select O
ptions > Save. You can save it to the Message
Terminal or to a USB memory stick.
6. Select P
rint if you want to print the message on your connected printer.
7. If you want to clear the editor and start a new message, select N
ew.
To Next Page
Loading...
