From the Inbox or Sent items
You can only print a message from within the message, as shown in the
previous section.
To delete or save messages from the Inbox or Sent items, do as follows:
1. Click in the lower left corner of the display.
2. Select the messages you want to delete or save.
You may use Select all to select all messages in the Inbox or Sent items, or
Clear all to clear all selections.
3. Select Delete to delete the selected messages or Save to save the selected
messages.
Receiving telex messages
The system can receive telex messages on all MF and HF telex frequencies,
including NAVTEX messages at 490 kHz, 518 kHz and 4209.5 kHz.
When a telex is received on your Message Terminal, the procedure is:
1. A popup appears and the telex page opens, showing the incoming
message.
2. If the call is an ARQ call, you can continue the communication as described
in Making a telex call on page 16.
All received telex messages, whether they are ARQ telexes initiated by the
other part or FEC telexes, are shown in the Inbox.
You can only receive telexes on frequencies that you are scanning.
This means that the frequencies must be in the scan list, and a
scanning must be started. See the next section for details.
Exception for DSC subsequent communication: The radio will
automatically enable scanning on the correct frequency and only on
that frequency. When the DSC session is ended, the scan list of the
Message Terminal is used again.
To Next Page
Loading...
