Sainlogic FT0073 - 页 24

If the arrow points upward, the temperature is increasing at a rate of
+2°C per 30 minutes (or greater). If the arrow points downward, the
temperature is decreasing at a rate of -2°C per 30 minutes (or less).
5. Console Operation
Note: The console has three buttons for easy operation:
MIN/MAX/- button, ALARM/ADJUST button, and CHANNEL/+ button.
5.1 Channel Selection
Press the CHANNEL/+ button to switch the display between the
Channel 1 temperature and humidity, Channel 2 temperature and
humidity, Channel 3 temperature and humidity, indoor temperature and
humidity .remote sensors 4 through 8, and scroll mode .The
channel indication arrow will point at the selected channel. In scroll
mode, the indoor temperature and humidity, and Channels 4-8 will
alternately be displayed in five second intervals.
5.2 High and Low Alarm
You can set a high and low temperature and humidity alarm on the
Channel 1, Channel 2, Channel 3 and Indoor temperature and
humidity. If the alarm is exceeded, a audible alert will occur and the
alarm value will flash. To silence the alarm, press any button.
To set the alarm, or adjust the high and low alarm settings, press the
CHANNEL/+ button until the channel indication arrow points at
the selected channel.
5.2.1 Alarm Defaults
-24-
Channel
Indoor
1,2,3
Default
Condition
OFF
OFF
HI ALARM
(temperature) ºF
60
35
LOW ALARM
(temperature) ºF
-20
10
HI ALARM
(humidity) %
90
80
LOW ALARM
(humidity) %
30
40