Sako SKI600 - Page 34

028
D Group - Monitoring Parameter Group and Fault Record
Function
Code
Name Set Range
Minimum
Unit
Factory
Default
Modi󽗉cation
d-44
Special model monitoring
parameter (reserved)
— — 0 ◆
d-45
Special model monitoring
parameter (reserved)
— — 0 ◆
d-46
Special model monitoring
parameter (reserved)
— — 0 ◆
d-47
Special model monitoring
parameter (reserved)
— — 0 ◆
d-48 The third to last fault type 0～30 1 0 ◆
d-49
The second to last fault
type
0～30 1 0 ◆
d-50 Last fa ult type 0～30 1 0 ◆
d-51 Current fault type 0～30 1 0 ◆
d-52
Run frequency of current
fault
0.00 ～【F0.16】upper
limit of frequency
0.01Hz 0.00 ◆
d-53
Output current of current
fault
0.0 ～ 6553.5A 0.1A 0.0 ◆
d-54
Busbar voltage of current
fault
0 ～ 999V 1V 0 ◆
d-55
Input terminal status of
current fault
0 ～ FFH
Note: sequence from
high to low order digit in
binary system
X8/X7/X6/X5/X4/X3/X2/X1
1 0 ◆
d-56
Output terminal status of
current fault
0 ～ FH
Note: sequence from
high to low order digit in
binary system R1/Y2/Y1
1 0 ◆
d-57 Run state of current fault 0 ～ FFFFH 1 0 ◆
4.0 Monitoring Parameter Group and Fault Record