Sako SKI600 - Page 67

061
4.1 Function Code
F9 Group - MS and PLC Running, Traverse and Fixed Length Control
Function
Code
Name Set Range
Minimum
Unit
Factory
Default
Modi󽗉cation
F9.57 Amplitude control
0: 󽗉xed amplitude
1: varied amplitude
1 0 ×
F9.58
Restart method of traverse
mode
0: start to the state
before stop
1: restart without other
requirement
1 0 ×
F9.59
Save traverse state upon
power failure
0: save
1: not save
1 0 ×
F9.60 Preset traverse freq.
0.00Hz ～ upper limit
Freq.
0.01Hz 10.00 ○
F9.61
Preset traverse freq. hold
time
0.0 ～ 3600.0s 0.1s 0.0 ×
F9.62 Traverse amplitude 0.0 ～ 100.0％ 0.1% 0.0% ○
F9.63 Step freq.
0.0 ～ 50.0％ (of
amplitude)
0.1% 0.0% ○
F9.64 Traverse rising time 0.1 ～ 3600.0s 0.1s 5.0 ○
F9.65 Traverse falling time 0.1 ～ 3600.0s 0.1s 5.0 ○
F9.66 reserved — — 0 ◆
F9.67 Length control 0: disabled 1: enabled 1 0 ×
F9.68 Preset length 0.000 ～ 65.535(KM) 0.001KM 0.000 ○
F9.69 Actual length 0.000 ～ 65.535(KM) 0.001KM 0.000 ○
F9.70 Length factor 0.100 ～ 30.000 0.001 1.000 ○
F9.71 Length calibration 0.001 ～ 1.000 0.001 1.000 ○
F9.72 Shaft circumference 0.10 ～ 100.00CM 0.01CM 10.00 ○
F9.73 Pulse per revolution (X7) 1 ～ 65535 1 1024 ○