Sako SKI600 - Page 78

072
4.1 Function Code
FE Group - Panel Function Setting and Parameter Management
Function
Code
Name Set Range
Minimum
Unit
Factory
Default
Modi󽗉cation
FE.10
Monitoring parameters
selection 1 in stop status
0～57 1 1 ○
FE.11
Monitoring parameters
selection 2 in stop status
0～57 1 12 ○
FE.12 Parameter display mode
LED one's place: function
parameters display mode
0: display all function
parameters
1: only display parameters
di󽗈erent from default value
2: only display parameters
modi󽗉ed after power on of
the last time (reserved)
LED ten's place: monitoring
parameters display mode
0: only display main
monitoring parameters
1: alternate display of main
and auxiliary paramete rs
(inte rval time 1S)
LED hundred's place and
thousand's place: reserved
1 00 ○
FE.13 Parameter initializatian
0: disabled
1: restore to factory
defaults (all user
parameters except motor
parameters)
2: restore to factory
defaults (all user
parameters)
3: clear fault record
1 0 ×