Salus ST100ZB - 8 Operation; Operating Modes

8-1
Module 5 – Connected Fan Coil Controls
Operation
Section 8
Operating Modes
Fan Coil Thermostats, Controllers and Remotes can be operated in the following operating modes:
• Standalone Mode* – when not part of a network
• Local Mode – when disconnected from the gateway
• Simple Mode – when connected to the gateway
• Remote: Not Connected – when remote is not on a network and/or not paired with a controller
* For SC102ZB & ST103ZB, Standalone Mode is when the SC102ZB Controller and ST103ZB Remote are paired but not
connected to a network.
Table 8.1: Operating Modes
Operation
Remote:
Not
Connected
Standalone Mode
Local Mode Simple Mode
ST100ZB/
ST101ZB
SC102ZB/
ST103ZB
Network
State
None
Thermostat is
not part of a
network
SC102ZB acts
as a Zigbee
coordinator
Thermostat is
part of a network,
disconnected from
SG888ZB
Thermostat is
connected to
SG888ZB Universal
Gateway
RF Icon
Display
None None
(Flashing)
SALUS
Smart Home
Icon
None None None None
SetPoint
Change
Not
Available
Device Only Device Only
Device or SALUS
Smart Home
application
Schedule
Not
Available
In Device, if enabled
In Device,
if enabled
In SALUS Smart
Home application
Change Fan
Speed
Not
Available
Device Only Device Only
Device or SALUS
Smart Home
application
Mode
Change
Not
Available
Device Only Device Only
Device or SALUS
Smart Home
application
Installation
Setup
Not
Available
Device Only Device Only
Device or SALUS
Smart Home
application
Rule based
operation
Not
Available
No No
Through SALUS
Smart Home
application