- 9 -
1-7. Adjustments and Settings
The ELLIX 30/40 is set up at the factory to be appropriate for most users. It does, however,
offer some settings for users with special requirements.
The ELLIX 30 has DIP switches that allow you to change communication settings, such as
handshaking and parity check, as well as printing density.
The ELLIX40 has a near-end sensor for the paper. This can give you a warning when the
paper is almost out. If you find that there is not enough paper remaining on the roll when
the near-end detector is triggered.
See the next page if you need to make any of these changes.
To Next Page
Loading...
