Sam4s ellix 30 - 1-5. Connecting the Power Supply

- 4 -
1-5. Connecting the Power Supply
Use the optional Power supply for your printer.
If the power supply’s rated voltage and your outlet’s voltage do not match, contact your
dealer for assistance. Do not plug in the power cord. Otherwise, you may damage the
power supply or the printer.
1. Make sure the printer is turned off.
2. If it is necessary to connect the interface, plug the interface connector into the
interface port on the printer.
3. Plug the DC cord connector into the power jack on the printer.
4. If it is necessary to connect the drawer, plug the drawer connector into the drawer
port on the printer.