- 6 -
1-6-1. Partition Installation
You can install the partition for 58mm paper printing on ELLIX30/40.
1. Push the Open-Button and open the Cover-Open.
2. Insert the Partition into the Paper-Supply as shown.
3. Push the Partition until it locks firmly in place.
1-6-2. Wall Mount Installation
1. Drill the wall to make the three holes ø6.5mm, depth over 35mm and put the three
anchors ⓐ into the each hole. (Notice the position of the holes.)
2. Tighten the three screws ⓑ into the each anchor to fix the BRKT-Wall to the wall as
shown.
3. Hang the printer on the three hooks and fix it down.
To Next Page
Loading...
