Sam4s ellix 30 - Table of Contents

- 1 -
Table of Contents
CHAPTER 1. SETTING UP THE PRINTER..................................... 2
1-1.
UNPACKING ................................................................................2
1-2.
CONNECTING THE CABLES...............................................................2
1-3.
CONNECTING THE COMPUTER...........................................................3
1-4.
CONNECTING THE DRAWER .............................................................3
1-5.
CONNECTING THE POWER SUPPLY.....................................................4
1-6.
INSTALLING OR REPLACING THE PAPER ROLL........................................5
1-6-1. Partition Installation..........................................................6
1-6-2. Wall Mount Installation......................................................6
1-6-3. Paper Roll Installation .......................................................8
1-7.
ADJUSTMENTS AND SETTINGS..........................................................9
1-7-1. Serial Interface(RS-232C) DIP Switch Set..........................10
1-7-2. Parallel Interface DIP Switch Set......................................11
1-8.
USING THE PRINTER ...................................................................12
1-8-1. Control Panel (LED) ........................................................12
1-8-2. Feed Button ...................................................................12
1-8-3. Panel lights : LED (Color) ................................................12
1-8-4. Control Panel (LCD) ........................................................13
1-8-5. Feed Button ...................................................................13
1-8-6. Function Button..............................................................13
1-8-7. Display status : LCD........................................................13
1-8-8. Setting mode for LCD Display ..........................................14
CHAPTER 2. APPENDIX............................................................. 16
2-1.A
DJUSTING THE PAPER NEAR-END SENSOR LOCATION.........................16
2-2.P
RINTER HEAD CLEANING..............................................................17
2-3.E
RROR STATUS AND ERROR RESOLUTION...........................................18
2-4.
SPECIFICATION..........................................................................20
2-4-1. General Printer specification ............................................20
2-4-2 Paper specification...........................................................20