Sam4s ellix 30 - 2-3. Error Status and Resolution

- 18 -
2-3. Error Status and Error Resolution
The printer buzzer sounds momentarily or continuously and the ERROR LED blinks when
the printer indicates an Error status.
Error Status Indicators include:
 Cutter Jam ( Buzzer and ERROR LED status )
If buzzer and ERROR LED beeps or blinks as like
“Beep Beep ---, Beep Beep--- …“, the printer is on Cutter Jam error status.
Cutter Jam
1. Open and close the cover2~3times.
2. Open the printer cover, remove the roll and jammed paper and load a new paper
roll.
3. Power off and on the printer, or send the DLE ENQ n command to reset the printer.