Sam4s ellix 30 - Chapter 2: Appendix; 2-1. Adjusting Paper Near-End Sensor

- 16 -
Chapter 2. APPENDIX
2-1. Adjusting the Paper Near-End Sensor
Location
The sensor has five sensitivity settings. The factory default setting is at position #3.
1. Push the open button and open the printer cover.
2. If you find there is too much paper remaining when the sensor is triggered, set the
near end sensor to position #4 or #5.
3. Decrease the setting if the paper runs out before the sensor is triggered.
The accuracy of the Near-End sensor depends on the adjustment scale setting and the
winding core diameter of the roll paper. The Near-End sensor is set at adjustment #3. This
is the appropriate scale for the recommended paper thickness.