OPERATOR’S Manual
11
CHAPTER 1
1.6.2. Wall Mount Installation
1. Use the template for Wall Mounting and mark the wall where you want
to install the printer.
2. Drill 3 holes in the marked places (diameter 6.5mm depth 35mm). Insert
the wall plug (A) into the hole.
3. Insert the screws into the wall plugs as in picture 3.
4. Assemble the wall mount bracket on the bottom of the printer using
the screws.
5. Place the printer according to the screw head located on the anchor
and fit it on the wall by sliding down.
108mm
44mm
➊
➌
ⓐ
ⓑ
➋
➍
➎
To Next Page
Loading...
