SAMES KREMLIN 20F50 - Page 145

582156110-EN-indC-Pump-20F50 pH.docx 20/11/2020
145
 Insert the 3 washers (23) on the tie rods (22) and screw
on the 3 nuts (24) with a 17 mm open-end wrench.
 Position the reversing block (9a/9b) on the upper
flange (2).
 Tighten the 2 screws (10) with a 6 mm Allen wrench.
Tools needed
23
22
24
10
10
6
16