Fault/diagnostic alarm
Value (hex) Status alarm acc. to
Profile 3.01
Friction
Much higher over whole range
0x80 GOOD_NON_SPECIFIC
Much lower over whole range
0x80 GOOD_NON_SPECIFIC
Much higher over partial range
0x80
GOOD_NON_SPECIFIC
Much lower over partial range
0x80
GOOD_NON_SPECIFIC
Much higher over whole range (TEST)
0x80 GOOD_NON_SPECIFIC
Much lower over whole range (TEST)
0x80 GOOD_NON_SPECIFIC
Much higher over partial range (TEST)
0x80 GOOD_NON_SPECIFIC
Much lower over partial range (TEST)
0x80 GOOD_NON_SPECIFIC
Leakage in pneumatics
Perhaps existing (TEST)
0x80
GOOD_NON_SPECIFIC
Perhaps existing
0x80
GOOD_NON_SPECIFIC
Perhaps too large (TEST)
0x80
GOOD_NON_SPECIFIC
Perhaps too large
0x80
GOOD_NON_SPECIFIC
Limit range
Down
0x80
GOOD_NON_SPECIFIC
Up
0x80
GOOD_NON_SPECIFIC
Modification impossible
0x80
GOOD_NON_SPECIFIC
Dynamic stress factor
Load factor > 90 %
0x80
GOOD_NON_SPECIFIC
Inner leakage (shut-off)
Perhaps existing
0x80
GOOD_NON_SPECIFIC
Perhaps larger than in original state (TEST)
0x80
GOOD_NON_SPECIFIC
Perhaps larger than original state
0x80
GOOD_NON_SPECIFIC
External leakage
Perhaps soon expected
0x80
GOOD_NON_SPECIFIC
Perhaps existing
0x80
GOOD_NON_SPECIFIC
Existing
0x80
GOOD_NON_SPECIFIC
KH 8384-4 EN 23
Status alarm according to Profile 3.01
To Next Page
Loading...
