Code
no.
Parameter – Display, values
[default setting]
Description
Note: Codes with marked with an asterisk (*) must be enabled with Code 3 prior to configuration.
47*
Write protection HART
[No] · YES
ESC
When the write protection function is activated, device data can
only be read, but not overwritten over HART
®
communication.
48*
49*
Diagnostics Refer to EB 8389 on EXPERTplus Valve Diagnostics
Note: The error codes listed in following appear in the display corresponding to their status
classification set over the condensed state (Maintenance required/Maintenance demanded:
, Out of specification: blinking, Maintenance alarm: ). If “No message” is assigned
to the error code as the status classification, the error is not included in the condensed state.
A status classification is assigned to every error code in the default setting. The status classifi
-
cation of error codes can also be changed as required using an operating software (e.g.
TROVIS-VIEW).
EB 8387-3 EN 75
Code list
To Next Page
Loading...
