Samson TROVIS 5578-E - Setting the Party Timer (Special Time-Of-Use)

KA 5578-E EN 15
Operation
5.2.3 Setting the party timer (special time-of-use)
Rated operation in the corresponding control circuit (HC1, HC2, HC3 or DHW) is started or
continued for the time period set in the party mode. When the party timer has elapsed, the
party timer returns to --:--.
Parameters WE Value range
HC1 party timer --:-- h 0 to 48h; in steps of 15 minutes
HC2 party timer --:-- h 0 to 48h; in steps of 15 minutes
HC3 party timer --:-- h 0 to 48h; in steps of 15 minutes
DHW party timer --:-- h 0 to 48h; in steps of 15 minutes
Turn the rotary switch to (special times-of-use). The party
timer for the rst control circuit is now selected.
q Set time for party mode of another control circuit, if re-
quired:
– Heating circuit HC2
– Heating circuit HC3
– DHW heating
Î Only those control circuits are available for selection
which can be controlled by the selected system.
¼ Activate editing mode for the party timer. The party tim-
er is now in the editing mode (inverted display).
q Extend day operation as required.
(in steps of 15 minutes)
¼ Conrm setting.
After setting the party timer:
Turn the rotary switch back to
(operating level).
Party timer runs down in steps of 15 minutes.
Note