Samson TROVIS 5578-E - Programming Vacation Periods (Special Times-Of-Use)

KA 5578-E EN 17
Operation
After programming all public holidays:
q Select 'Back'.
¼ Exit the public holiday setting.
Turn the rotary switch back to
(operating level).
Public holidays that are not assigned to a specic date
should be deleted by the end of the year so that they are not
carried on into the following year.
5.2.5 Programming vacation periods (special times-of-use)
The system runs constantly in reduced mode during vacation periods. A maximum of ten va-
cation periods can be entered. Each vacation period can be separately assigned to the heat-
ing circuits HC1, HC2, HC3 and DHW circuit or to all control circuits.
If a vacation period is programmed to apply to all control circuits, it also applies to control
circuits HC11, HC12 and HC13.
Parameters WE Value range
Vacation period --.-- - --.-- 01.01 to 31.12
Turn the rotary switch to (special times-of-use). The party
timer for the rst control circuit is now selected.
q Select 'Vacations'.
Note
Note