Samson TROVIS 5578-E - Page 18

18 KA 5578-E EN
Operation
¼ Start the vacations setting. The rst vacations setting is
now selected. --.-- - --.--.is displayed if no vacations (de-
fault setting) have been programmed.
q Select --.-- - --.--, if applicable.
q Activate editing mode for vacations.
The start date can now be edited (inverted reading).
q Set the start date.
q Conrm the start date.
The end date can now be edited.
q Set the end date.
q Conrm the year setting. 'All' is selected. The vacation
period then applies to all control circuits.
q If the vacation period is to be only valid for one control
circuit, select the required control circuit:
– Heating circuit HC1
– Heating circuit HC2
– Heating circuit HC3
– DHW heating
Î Only those control circuits are available for selection
which can be controlled by the selected system.
The control circuits HC11, HC12 and HC13 are not
available.
¼ Conrm the control circuit.
An active vacation period is indicated on the display by the
icon.
Proceed in the same manner to program further vacations.
Note