Samsung CLX-8540ND - Page 118

Maintenance and Disassembly
Service Manual
3-39
Samsung Electronics
3. Remove the 3 screws and all harness connected
to scan assy.
4. Lift up and release the Platen Assy.
1. Remove the 6 screws (cap hole screw 3 EA) 2. Open the side cover. Pull both bottom sides of
the scan upper , lift up and release it.
1
2
3
1
2
3
3.2.2.4.2 Scan upper (Scan glass)
Note – Before disassembling the platen unit, remove the DADF unit (3.2.2.2) and OPE unit(3.2.2.3)
But, when replacing the DADF, Scanner, OPE unit on the whole, it is not necessary.