3.2.2.7 SMPS board and FDB board
1. Remove 12 screws. And remove the Cover rear
and the Cover rear lower.
2. Remove 3 screws. Unplug the harness.
And release the SMPS shield.
3. Unplug the all harness and remove the 8 screws.
And release the SMPS board from the shield.
4. Unplug the all harness and remove the 4 screws.
And release the FDB board from the shield.
Caution
When reassembling the SMPS shield cover, be
careful not to cut the harness.
To Next Page
Loading...
