4-72
Troubleshooting
● Possible Cause:
1. Harness is defective, Connector is not connected properly.
2. Sensor is defective.
● Error message : Door is open. Close it
● Troubleshooting method :
● Symptom : Side Cover is Opened.
● Code : 01-000
3. Enter the EDC mode. Follow the below sequence.
( EDC Mode Î Test Routines Î Copier Engine/DADF Test Routine Î 101-170 Î Start Î Status check
Î Stop )
1
2
1. Check if the Harness is defective.
Check if the connector is connected properly.
COVER OPEN
UPPPER
COVER OPEN
LOWER
2. Push the Side Cover Sensor switch from 1 to 2. Check if the UI message is changed. When pushing the
switch, you have to push both of them at once.
4.4.3 Troubleshooting for error code
To Next Page
Loading...
