4-81
Troubleshooting
● Possible Cause:
1. Pickup Clutch does not work.
2. Pickup roller rubber is worn out.
3. Feed Sensor is defective.
● Error message : Paper jam in tray 3
● Troubleshooting method :
● Symptom :
At printing, the paper from the tray3 has not reached to the feed sensor within a regular time after pick up.
● Code : 01-007
01-012
01-019
1. Check the following.
-. Check if the Tray3 Motor and Pick-Up Clutch are
assembled properly.
-. Check if the Tray3 Motor harness and Pick-Up Clutch
harness are connected properly.
-. Enter the EDC mode. Execute the Tray3 Pick-Up Clutch
test.
(EDC Mode Î Test Routines Î Copier Engine/DADF
Test Routine Î 101-030 Î Start Î Operation Check Î
Stop)
2. Check if the Harness is defective.
Check if the connector is connected properly.
To be continued on next page…
To Next Page
Loading...
