4-151
Troubleshooting
● Possible Cause:
IF_Under connector is defective.
● Error message :
Tray2 is not installed
Tray3 is not installed
● Troubleshooting method :
● Symptom :
Tray2 (3 or HCF) is installed but not detected.
● Code :
21-016
21-024
1. Check if the IF_Under connector on the engine board is connected properly.
2. Check if the IF_Under connector on the tray2 (3 or HCF) board is connected properly.
3. Check if the connector between the machine and the tray2 (3 or HCF) is connected properly.
To Next Page
Loading...
