4-153
Troubleshooting
● Possible Cause:
1. The connector of the Tray2(3/ HCF) Home Position Sensor is not connected properly.
2. Tray2 (3/ HCF) Home Position Sensor is defective.
● Error message :
Tray2(or HCF) cassette is pulled out. Insert it properly
Tray3 cassette is pulled out. Insert it properly
● Troubleshooting method :
● Symptom :
Tray2 (or HCF) cassette is inserted in machine but error message is displayed.
Tray3 cassette is inserted in machine but error message is displayed.
● Code :
21-019
21-027
2. Check the following.
-. Check if the Tray2 (3/ HCF) Home Position Sensor is assembled properly.
-. Check if the Tray2 (3/ HCF) Home Position Sensor harness is connected properly.
-. Enter the EDC mode. Execute the Tray2(3/ HCF) Home Position Sensor test.
(EDC Mode Î Test Routines Î Copier Engine/DADF Test Routine Î 102-070(102-140)Î Start Î
Operation check Î Stop)
1. Check if the Harness is defective.
Check if the connector is connected properly.
To Next Page
Loading...
