2.3.2.1 Video Controller
The Video Controller which is used to control printing, copying, scanning, and FAX functions comprises
a 800MHz Fereceon core (ARM v5TE), an image processor (CIP6) with 256MB SDRAM, 1024MB DDR2
DIMM, Flash memories, SATA HDD interface. The Video controller includes an embedded network that
supports 10/100/1000M Network and also provides USB host 2.0, device. The Video controller board is
connected to the Engine controller with a 80 pin draw connector and communicates with USB interface and
video clock/data. The Scanner Part including DADF & CCD is connected to the Video controller through the
Scan Interface PBA.
When replacing the Video controller, you must insert the previous MSOK on the new video
controller.
To Next Page
Loading...
