6. Pull the used imaging unit out of the machine
using the handle on its bottom.
7. Remove the new imaging unit from its bag.
8. Remove the paper protecting the surface of the
imaging unit.
9. Remove the cap, and carefully pull the seal
tapes out of the imaging unit.
10. Thoroughly shake the new imaging unit side to
side ve or six times.
11. Labels inside the machine identify each imaging
unit’s position.
Holding the handles on the new imaging unit,
push the imaging unit until it locks in place.
12. Turn the imaging unit locking levers inwards
until it locks in place and close the inner cover.in
13. Insert the waste toner container into position
and then push it to make sure that it is rmly
seated in place.
14. Close the front cover, then the side cover.
15. Make sure that the cover is securely latched
and then turn the machine on.
To Next Page
Loading...
