Samsung DCS-816 - 2.6 INDIVIDUAL STATION PAGE

SAMSUNG System Administration and Special Features Guide
DCS-816 March 1999
3 - 4
The # key is used to select the following special characters (in sequence of key presses):
# space & ! : ? . , % $ - < > / = [ ] @ ^ (
) _ + { } | ; "
→
→→
→
`
3.5 PROGRAM TRUNK NAMES
[MMC 404]
This program is used to assign a name or identification to each C.O. line. You may assign
a name up to 11 characters long.
PROGRAM KEYS
UP & DOWN Select trunk and move cursor.
KEYPAD Used to enter characters.
HOLD Press to clear entry.
Open customer programming and follow the instructions below.
ACTION DISPLAY
1.
Select 404 [701] TRUNK NAME
2.
Dial trunk (e.g., 704)
OR press UP or DOWN to select trunk and press the
[704] TRUNK NAME
right soft key to move the cursor
3. Enter the trunk name using the procedure in 3.4 Pro-
gram Station Names and press the right soft key to
[704] TRUNK NAME
SAMSUNG
return to step 2
4.
Press TRSF to store and exit programming
OR press SPEAKER to store and advance to the next
program