Connecting the Connection Cord
The indoor unit is powered from the outdoor unit via the connection
cord.
When connecting the cables, you must pass them through
the cable clamp to fix them securely.
Connect the Connection Cord as seen in next picture ,
and the torque of screw is 40~70kgf•cm .
Note
Remove the screw on the electrical component box and remove the cover
plate.
1
Route the connection cord through the side of the indoor unit and con-
nectthe cable to terminals as shown in page 12.
2
Route the other end of the cable to the outdoor unit through the ceiling &the
hole on the wall.
3
Reassemble the electrical component box cover, carefully tightening the-
screw.
4
To Next Page
Loading...
