Preparation for Installation
When deciding on the location of the air conditioner with the owner,
the following restrictions must be taken into account.
Do NOT install the air conditioner in a location where it will come into
contact with the following elements:
Combustible gases
Saline air
Machine oil
Sulphide gas
Special environmental conditions
If you must install the unit in such conditions, first consult your dealer.
Cable-Tie Cable Clamp
M4 x 16 Tapped
Screws
Indoor unit power draw-
ing cable
Communication cable
ofthe wired remote con
-
troller
Wire joint
Owner’s Instruction
Installation Manual
Wired remote controller
Accessories
General
Wired Remote Controller Accessories
The following accessories are supplied with the indoor unit.
The type and quantity may differ depending on the specifications.
Installation
Manual(1)
Owner’sInstruc-
tions(1)
Insulation Cover
Pipe in(1)
Insulation
Cover Pipe out(1)
Insulation Pipe in(1)
Insulation
CoverDrain(1)
Insulation Pipe out(1)
Clamp hose(2)
Cable-Tie(8)
Flexible hose(1)
Insulation Drain (1)
Rubber(8)
To Next Page
Loading...
