Assigning Address to Indoor Unit
Before installing the indoor unit, assign an address to the indoor unitac-
cording to the air conditioning system plan..
1
The address of the indoor unit is assigned by adjusting MAIN(SW02)
andRMC(SW04) rotary switches.
2
It is required to set the RMC address if you install the wired remote control-
lerand/or the centralized controller.
3
If you install optional accessories such as the wired remote controller, cen-
tralizedcontroller, etc. see an appropriate installation manual.
4
If an optional accessory is not installed, you do not have to set the
RMCaddress. However, adjust K1 and K2 switches of the SW05 DIPswitch
to “ON”position in this case.
5
To Next Page
Loading...
