Samsung DVM - Page 4

4
PREPARATION
Do not install this product near a heater, inammable material. Do not install this
product in a humid, oily or dusty location, in a location exposed to direct sunlight and
water (rain drops). Do not install this product in a location where gas may leak.
y
Potential risk of electric shock or re.
Do not attempt to move or re-install the product that is already installed.
y
There is risk of electric shock or re.
Do not attempt to repair, disassemble, or modify the product yourself.
y
There is risk of product damage, electric shock or re. When repair is needed,
consult service center.
For installation
CAUTION
Install the product on a hard and even place that can support its weight.
y
If the place cannot support its weight, the product may fall down and it may cause
product damage.
Make sure there is no tension to the cable during installation.
y
Cable may get cut and cause re.
Install the product in a place with temperature between 0~39°C (32~102°F) with
no direct sunlight.
y
If not, there is risk of re or product malfunction.
Do not install the product in a place where special spray or acid/alkali solution is used.
y
If not, there is risk of re or product malfunction.
Do not connect the power cable to the communication cable terminal.
y
There is risk of re.
When installing the product in hospitals or other places, make sure that the product
does not interrupt with other products.
y
If not, there is risk of product malfunction.
Do not allow water to enter the product.
y
If not, there is risk of electric shock or re.
Do not press the buttons with any sharp objects.
y
There is risk of electric shock or damage to the parts.
Safety precautions