SAMSUNG
This Document can not be used without Samsung’s authorization
8-1
Disassembly and Reassembly
8. Disassembly and reassembly
8-1 Disassembly of main unit
1. Set up the repair table where the anti-static mat is installed to disassemble and reassemble the camera.
2. When handling the key PCB of the camera, wear the anti-static band on the wrist to prevent any error from
static electricity.
3. When handling key parts, be careful of the following.
Precaution for disassembly/reassembly
Part Precaution
F PCB Type
When assembling the F PCB to the CONNECTOR with a pin set, be careful not to cause dents or
tears on the PCB.
CCD and IR CUT
When handling the parts, be careful not to leave any ngerprints.
Use the pin set with soft tips.
When cleaning the parts with alcohol, be careful not to cause any stains.
Do the repair work in a dust free environment.
PCB Type
Always use the anti-static mat and wrist band, as the parts can be damaged from static electricity
from the hand.
CONTACT Type
Be careful of damage of deformation of parts from the pin set.
<Table 9-1>
To Next Page
Loading...
Need help?
General
Weight and Dimensions
