Shooting Functions
To capture a realistic photo of a subject, the amount of light should be
constant. When the light source varies, you can use a ash and supply a
constant amount of light. Select appropriate settings according to a light
source and a subject.
To set ash options,
In Shooting mode, press [m]
ĺ
b
ĺ
Flash
ĺ
an option.
Icon Description
O: The ash is o.
Smart Flash: The camera automatically adjusts the brightness
of the ash according to the amount of light in the surrounding
environment.
Auto: The ash automatically res in dark locations.
Auto Red-eye: The ash automatically res and reduces red-eye.
Fill-in: The ash res whenever you capture a photo. (Brightness is
automatically adjusted.)
Fill-in Red: The ash res whenever you capture a photo and
reduces red-eye.
1st Curtain: The ash res
immediately after the shutter opens.
The camera captures a photo of a
subject earlier in an action sequence
clearly.
Direction of ball's motion
Icon Description
2nd Curtain: The ash res just
before the shutter closes. The
camera captures a photo of a
subject later in an action sequence
clearly.
Direction of ball's motion
Hi-speed: If the shutter speed is faster than the camera’s sync
speed (the shortest time taken to open and close the shutter), the
ash will re multiple times at high speed. The ash starts to re
while the shutter opens. This option can be set only when you
attach a compatible, optional external ash. (SEF-580A)
The available options may dier depending on shooting conditions.
When you use Red-eye correction, there is an interval between two bursts of
the ash. Do not move until the ash res a second time.
If you select O, the ash does not re even when an external ash is
attached. If you adjust the ash intensity manually, the ash will re once
without a pre-ash.
Use only Samsung-approved ashes. Using incompatible ashes may damage
your camera.
Flash
To Next Page
Loading...
