Configuring the IP Phone DS/ITP-5012L Phone User Guide
14
The next menu to appear will display different options depending on your
selection. These are described next. If you selected [2. DHCP] your settings
are automatically completed and you can proceed to Load & Upgrade Set-
tings, below.
Setting Manual IP
If you selected the [1. Manual IP] menu you see the following options:
1. Select [2. IP] to display the phone’s current
IP address. (No address is displayed if an IP
address has not yet been set.)
Use the dial buttons [0] to [9] and [4] to enter a new IP address, and
press the [Enter] button.
(Note: Take care not to enter a duplicate IP address as the network does not sup-
port redundant IP addresses.)
2.
Select [3. Netmask] to display the current
Netmask address. To change the Netmask
address, enter a new value and press
the [Enter] button.
To Next Page
Loading...
