Samsung SCX-6555N - Page 177

Alignment & Troubleshooting
Service Manual
4-77
Samsung Electronics
9) Finisher
Code Displayed Name Meaning
State
Displayed
12-100 Entrance Motor Entrance Motor run as IOT Speed <about 5 sec> On[Off]
12-110 Exit Motor Exit Motor run as IOT Speed <about 5 sec> On[Off]
12-200 Paddle Motor Paddling On
12-300 Front Jog Home Front Jogger move Home On
12-310 Front Jog Stand Front Jogger move to Stand On
12-320 Rear Jog Home Rear Jogger move Home On
12-330 Rear Jog Stand Rear Jogger move to Stand On
12-400 Support Finger Home Supporter move Home On
12-410 Support Finger Stand Supporter move to Stand On
12-500 Ejector Motor Ejecting On
12-600 Stacker Down Stacker down to bottom On
12-610 Stacker Up Stacker up to Stacking position On
12-700 Stapler Staple when no cartridge On
12-800 Entrance Sensor Detect paper at paper feeding area. High[Low]
12-805 Exit Sensor Detect paper at paper exit area. High[Low]
12-810 Paddle Home Sensor Detect Paddle Home position High[Low]
12-815 Front Jog Home Sensor Detect Front Jog Home position High[Low]
12-820 Rear Jog Home Sensor Detect Rear Jog Home position High[Low]
12-825 Support Finger Home
Sensor
Detect Support-Finger Home position High[Low]
12-830 Ejector Home Sensor Detect Ejector Home position High[Low]
12-835 Ejector Encoder Sensor Detect Ejector Encoder sensor High[Low]
12-840 Stacker Top Sensor Detect Stacker Top position High[Low]
12-845 Stacker Bottom Switch Detect Staple Bottom position High[Low]
12-850 Staple Home Sensor Detect Staple Home position High[Low]
12-855 Staple Ready Sensor Detect Staple Ready to clinching. High[Low]
12-860 Low Staple Sensor Detect Staple Low High[Low]
12-865 Paper Detector Sensor Detect paper in stapler area High[Low]
12-870 Finisher Door Switch Detect Finsher Door Open or Close High[Low]
12-875 IOT Set Sensor Detect Finisher is connected with IOT. High[Low]
12-880 Duplex Paper Sensor Deetct Duplex Paper feeding from IOT. High[Low]
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA