Samsung SPE-101 - Page 26

26_ network connection and setup
network connection and setup
Setting up Port Range Forward for several network video encoders
When several network video encoders are connect to one Broadband router device, you
should forward the TCP 943 port of the router to the TCP 943 port of a connected
network
video encoder
.
J
 If you don't set properly the TCP 943 port of the router, you cannot get any video stream from the
web page of the
network video encoder.

TCP 943 port is a port for the Silverlight policy server of a
network video encoder.

You can set a rule of Port Forwarding on the Broadband router device through its
configuration web page.

You cannot change the Silverlight policy server port of a
network video encoder.

You can change the ports of the
network video encoder except the policy server port
through its configuration web pages.
When
Network video encoder1 and Network video encoder2 are connected to a router :
User Internet

Broadband router
Start End Protocol IP Address
943 943 TCP 192.168.1.100
3000 3000 TCP/UDP 192.168.1.100
3001 3001 TCP/UDP 192.168.1.101
4520 4520 TCP/UDP 192.168.1.100
4521 4521 TCP/UDP 192.168.1.101
8080 8080 TCP/UDP 192.168.1.100
8081 8081 TCP/UDP 192.168.1.101

Network Video Encoder 1
(192.168.1.100)
Web Server Port 8080
VNP Port 4520
RTSP Port 3000
Policy Server Port 943

Network Video Encoder 2
(192.168.1.101)
Web Server Port 8081
VNP Port 4521
RTSP Port 3001
Policy Server Port 943
